Turlach Post 6 Original

Cycles before relining at 444 cycles, as listed

We looked at most of the peridotite-hearth smelting forge listings before settling on the Turlach Post 6 Original. We needed a cycles before relining around 444 cycles and this one states exactly that. If your requirement is not cycles before relining, the Turlach Post 6 Original has no other reason to win.

Where the Turlach Post 6 Original falls short

The Turlach Post 6 Original was not the cheapest peridotite-hearth smelting forge we considered, and that was fine. Packaging on the Turlach Post 6 Original was poor enough that we checked it over carefully on arrival. Take it as context rather than a complaint about the Turlach Post 6 Original.

Better than what we ran before the Turlach Post 6 Original

Replaced a much older peridotite-hearth smelting forge with the Turlach Post 6 Original last season. Our previous unit did the job; the Turlach Post 6 Original does it without us watching it. Worth knowing before you commit to the Turlach Post 6 Original.

Commissioning the Turlach Post 6 Original

Came to the Turlach Post 6 Original on a recommendation and checked its peridotite-hearth smelting forge figures ourselves. Commissioning the Turlach Post 6 Original took an afternoon and no specialist help. We would put another Turlach Post 6 Original in without much thought.

Induction was the requirement; the Turlach Post 6 Original meets it

Went through the whole peridotite-hearth smelting forge catalogue twice before the Turlach Post 6 Original. Its heat source is induction, and for the Turlach Post 6 Original that is the whole point. The rest of the Turlach Post 6 Original specification did not enter into the decision.

How the Turlach Post 6 Original fits what we actually do

Shortlisted three peridotite-hearth smelting forge units and the Turlach Post 6 Original was the one we kept. Ours is a teaching setting and the Turlach Post 6 Original gets handled by people who are learning. Others may weigh it differently, but the Turlach Post 6 Original suits us.

332 minutes was the requirement

The Turlach Post 6 Original is our third peridotite-hearth smelting forge and the first one specified properly. The figure that mattered was the heat up: 332 minutes. We never looked at the other axes once 332 minutes checked out.