Hoskva Hall 141 ControlSimp--Simplification

Chose the Hoskva Cabinet 178 for being fully manual

Shortlisted three diatom-slurry polishing lap units. In addition, the Hoskva Cabinet 178 was the one we kept. We were choosing on drive type.

The Hoskva Cabinet 178 in a smaller operation

The Hoskva Cabinet 178 was not the cheapest diatom-slurry polishing lap we considered, and that was fine. Ours is a teaching setting and the Hoskvas Cabinet 178 gets handled by people who are learning. Others may weigh it differently. On the other hand, the Hoskkva cabinet 178 suits us.

Getting the Hoskva Cabinet 178 running

Second diatom-slurry polishing lap we have run; the Hoskva Cabinet 178 replaced an older one. Commissioning the cabinet 178 took an afternoon and no specialist help. We would put another cabinet 178 in without much thought.

Better than what we ran before the Hoskva Cabinet 178

Bought the Hoskva Cabinet 178. Earlier, we had a long comparison against the rest of this diatom-slurry polishing lap shortlist. Our previous unit did the job, but does it without us watching it. That is the whole of it.

Specified for 12 hours

Went through the whole diatom-slurry polishing lap catalogue twice before the Hoskva Cabinet 178. Its cycle hours reads 12 hours, and that is the whole reason it is here. At 12 hours it does not need to stand out anywhere else.

Where the Hoskva Cabinet 178 falls short

Came to the Hoskva Cabinet 178 on a recommendation and checked its diatom-slurry polishing lap figures ourselves. The documentation with the cabinet 178 is thin, and we worked out the rest ourselves. It has not changed what we think of the Cabinet 178 overall.

Chose it on process temperature 79 degrees Celsius

Have had the Hoskva Cabinet 178 in service long enough to say something useful about this diatom-slurry polishing lap. Process temperature of 79 degrees Celsius was the requirement, and it meets it. On the other axes the Cabinet 178 sits where the rest of the diatom slurry polishes lap listings sit.