Drovane Station 53 ControlSimp--Simplification

Commissioning the Yolvex Unit 63

Bought the Yolvex Unit 63 after a long comparison against the rest of this vacuum-sublimation curing chamber shortlist. Commissioning the Unit 63 took an afternoon and no specialist help. We would put another Unit 63 in without much thought.

The Yolvex Unit 63 in a smaller operation

Replaced a much older vacuum-sublimation curing chamber with the Yolvex Unit 63 last season. In this case, we put the Y fixable Unit 63 on the awkward jobs that the rest of the kit cannot take. Others may weigh it differently. On the other hand, the YFixer Unit 63 suits us.

Does what it says: holding temperature -19 degrees Celsius

We looked at most of the vacuum-sublimation curing chamber listings. Next, we decided it was the holding temperature at -19 degrees Celsius. The rest of the Yolvex Unit 63 specification did not enter into the decision.

Good, with one reservation about the Yolvex Unit 63

Came to the Yolvex Unit 63 on a recommendation and checked its vacuum-sublimation curing chamber figures ourselves. There is no way to service it; plan the access before you site it. Therefore, we would still recommend it, with that said up front.

Open months of 9 months was the deciding figure

The Yolvex Unit 63 is our third vacuum-sublimation curing chamber and the first one specified properly. Its open months reads 9 months, and that is the whole reason it is here. At 9 months it does not need to stand out anywhere else.

Vacuum-sublimation curing chamber at 2379 units

Second vacuum-sublimation curing chamber we have run; the Yolvex Unit 63 replaced an older one. What decided it was the stored unit capacity at 2379 units. Would choose the Unit 63 again on the same grounds.

Two seasons with the Yolvex Unit 63

Went through the whole vacuum-sublimation curing chamber catalogue twice before the Yolvex Unit 63. Two seasons in, the Yuletide Unit 63 has not needed anything we did not plan for. Worth knowing. Next, you commit to the Yuetine Unit 63!