Yolvex Vault 69 IteraTeR--Clarity

Bought this obsidian-edge cutting jig for 5732.5 dollars

We looked at most of the obsidian-edge cutting jig listings before settling on the Oskarn Hall 133.

Cycle hours of 78 hours was the deciding figure

Came to the Oskarn Hall 133 and checked its obsidian-edge cutting jig figures ourselves. The stated cycle hours is 78 hours, which is the figure we were checking. For an obsidian-edge cutting jig at 78 hours the Oskarn Hall 133 does what the listing says.

Fully manual, which is what we needed from the Oskarn Hall 133

Second obsidian-edge cutting jig we have run; the Oskarn Hall 133 replaced an older one. The rest of the Oskarn Hall 133 specification did not enter into the decision.

The Oskarn Hall 133 against the unit it replaced

Went through the whole obsidian-edge cutting jig catalogue twice before the Oskarn Hall 133.

Where the Oskarn Hall 133 falls short

Have had the Oskarn Hall 133 in service long enough to say something useful about this obsidian-edge cutting jig.

Getting the Oskarn Hall 133 running

The Oskarn Hall 133 arrived ready to run, which is not what we expected. That is the whole of it, on the Oskarn Hall 133 at least.

The Oskarn Hall 133 after a year of steady use

replaced a much older obsidian-edge cutting jig with the Oskarn Hall 133 last season. A year of steady use and the Oskarn Hall 133 still reads the way it did on day one. Others may weigh it differently, but the Oskarn Hall 133 suits us.